Tuesday, March 09, 2010

TRY TO READ THIS... " STEPS IN MAKING METHAMPETAMINE"

I GOT THIS FROM LYCAEUM.ORG ON HOW TO MAKE A HOMADE "SHABU"... BUT BAD
NEWS TO ADDICTS OUT THERE.... THIS IS A HOAX... JUST ONE OF THE
PRODUCT OF IMAGINATION OF A CONTRIBUTOR HEHEHE....

THE TRIED AND TRUE HOME PRODUCTION METHOD
Break open the inhalers, a pair of real sharp scissors does this good.
Place the cottons that were inside in a jar and close the lid.
(Remember you use all 12 cottons.)
In the bowl, combine 1- 1/3 oz. water and 2/3 oz. muriatic acid. Shred
cottons in this solution, and knead for 5 minutes with hands. (ALWAYS
BE SURE THERE'S CLEAN RUBBER GLOVES on your hands.) You can do it
bare-handed if you' got tough skin. Squeeze all juice out of filters
after you knead, and throw em away.
Filter the remaining liquid into the quart jar. It will be necessary
to this several times to get that awful smelling oil out. The
chemicals in the inhalers have been bonded to the HCl, and the oils
have been filtered off. Throw the filters away.
Pour enough of the solution into a small bottle to fill it 1/3 full.
Save any leftover juice for the second batch.
Pour 1/4 teaspoon of the lye crystals into the bottle and agitate. Do
this carefully, as the mixture will become hot, and give off a gas.
Repeat this step until the mixture remains cloudy.
Fill the bottle from step (5) up the rest of the way with ether. Cap
the bottle, and agitate for about 8 minutes. It is very important to
expose ever molecule of the free-base to the ether for as long as
possible.
Let the mixture settle. There will be a middle layer that is very
thick. Tap the side of the bottle to get this layer as thin as
possible.
Remove the top layer with the eyedropper, being careful not to get any
of the middle layer in it. Save the top layer, and throw the rest
away.
Fill a bottle half-way with water, and about 10 drops of acid. Pour
the top layer from step (8) into the bottle, and cap it. Shake the
bottle for 2 minutes. When it settles, remove the top layer and throw
it away. The free base has now been bonded to the HCl/water mixture.
If there is anything left from step (3), repeat the procedure with it.
Evaporate the solution in the Pyrex dish on low heat. You can do this
o the stove, but I have found that if you leave it on top of a
hot-water heater (like the one that supplies hot water to your house)
for about 2-3 days, the remaining crystals will be Methamphetamine.

Post a Comment
Related Posts Plugin for WordPress, Blogger...